Way back on February 12, I said I was going to show you how to recover those cornice boards that are in RV’s everywhere. I really did think I was going to do that project the next day, but…..one thing happened and then another, and I didn’t have the right screwdriver to get mine down off the wall with, so it took a very long time for tomorrow to get here.
Today I finally decided it was time to get that thing off the wall and finish my RV bedroom makeover. To start, I had to get the cornice board off the wall. It was held in place with two long phillips head screws. The shade was also attached to the cornice board, so I had to figure out how to get it off of the cornice without tearing it up. The shades also have the string mechanism attached to the wall down near the mattress.
I decided to take the cornice down by taking out the two screws. I then detached the two smaller screws that held the shade to the cornice. I left the shade laying on the bed in just the same position it was in when I removed it from the cornice, and left the strings attached to the wall. That way, I would know how it went back together.
Once the cornice was off the wall, and the shade was off the cornice, I took the cornice outside to the tailgate of the truck. I knew it was going to be a messy job getting all the old fabric off, plus it was a very nice day outside. The first thing I needed to do was figure out how to get the two pieces apart. I found out they were held together with staples, so I got a long flathead screwdriver and pushed in between the two pieces, slowly, so I could wiggle the staples out. Once the two pieces were apart, I had to take off the decorative “button” on the outside piece in the same way:
After I had the pieces apart, I removed all the old fabric, and used it as a guide for how to cut the new fabric pieces. Once the new fabric was were cut, I stapled them onto the wood pieces. I don’t have a staple gun, so I used an ordinary office type stapler opened all the way out. It worked for the purpose, but I would suggest buying or borrowing a staple gun if you are going to do this project–it will certainly save your knuckles.
The first piece I covered was made of balsa wood, so the staples went in fairly easily. However, the second piece was laminated, and that made it very hard to staple with just that office stapler. So, I used 3M duct tape on the inside to hold the fabric in place. It isn’t going to show, and did the job very well.
When you have both pieces covered with the new fabric, you’ll need to fasten them back together. I just put the outside piece on top of the inner piece, and felt with my fingers to find the large staples that held them together. I placed a scrap piece of fabric over the area where the staple was, and hammered it down with a hammer. The last thing was to re-attach the decorative piece to the center of the cornice board. I also covered this wooden piece with some scrap fabric when I hammered it into place to prevent making any marks on it with the hammer.
It took me about two hours to complete this project. The hardest part was getting all the screws back in and getting the cornice back on the wall, mostly because my arms aren’t long enough. The shade went back on very easily, though.
Don’t you think this just completes my bedroom? It looks sooo much nicer to me.
