To rewire your house properly with minimal damage you need some basic knowledge about electrical power. TV, computer, blenders, refrigerators: none of these existed in houses when the first house was wired for electricity. With up-gradates in electrical systems, and more and more electric appliances, came the complications of wiring the house properly. Updating electrical devices and wiring the house accordingly can often results in a lot of damage if you try to do it yourself. Hence, asking help from a professional electrician is a must. Rewiring the house doesn’t seem to be that difficult task and can be done as a DIY program. Here are some tips to follow when rewiring the house yourself which will not only save you money but is more like a precautionary measure.
Precaution is a must
Before you begin with any rewiring project, make sure that you have taken all the preventive safety measures you can. Make sure to go over your safety checklist before you begin. Working with electricity has never been safe so you need to touch the wires with care and make use of a protective good quality eye wear.
Begin with electrical inventory
Make a list of the electrical devices that you will be using in the house. Then chose wiring that will handle the load of the electrical appliances you want to use. Making sure you have the right wire will assure that you won’t have to add a connection or two later.
Check local codes and work out the permits
There is usually a standard set of codes for everything from the number of outlets you can have in a room to the types of wire you can use. You need to follow the codes. Failure to do that means you may have to pull out the wiring and do it all over again.
Turning off the power supply
Always turn off the electric power before you begin with the process. It is a must to note down the amperage of your home appliances and then select appropriate sockets and wires. If you’re currently residing in Santa Monica LA, get assistance with the local electrician of plumbers in Santa Monica, and ask for some guidelines regarding the electrician.
Removing the old wires and installing the new
Here you might need some help from a professional for the rewiring project. Identify the power outlets, switches and lights that you would need for every circuit. If the house is old, it is important that you change the wire after a certain period to avoid any kind of accidents. Check the attic for the wiring that connects the breaker box and the power plug. Check the power outlet carefully to make sure that you do not make any hole in the wall or the roof.
The location of the power outlet can be easily traced when you follow the cable carefully. Use enough light to see the wires carefully and leave 7-8 inches in the breaker box and remove the rest. Replace the old wire with the new by peeling the insulation around 3-5 inches. Make a loop and wrap them together and secure it with an electric tape. Follow the same procedure for all the switches and outlets and once done check if the connections are working fine.