Joann Fabrics Turkey Tablescapes #turkeytablescapes

Thanksgiving is not only eating turkey and dressing and watching football games. For us in the Fab Household, it is also about crafts and making the table look good. This month, I decided to make three crafts: An easy one, an intermediate one, and an advanced one. See if you can guess which is which!

The first thing I made was a round tablecloth for my Thanksgiving Day table. I picked out a fabric that looked like fall:

Cranston VIP fabric from Joann Fabrics

Cranston VIP fabric from Joann Fabrics

I bought three yards of this Cranston VIP fabric from Joann. To cut the fabric, here is a graphic that shows how to:

How to cut fabric for a round tablecloth

How to cut fabric for a round tablecloth

When you get through cutting the fabric, you will have one piece that measures 72: X 44″; 2 pieces that measure 36″ X 11 inches; and 4 pieces that measure 18″ X 11″.

To put these pieces together, take one 36″ X 11″ pieces and 2 18″ X 11″ pieces, and sew one of the 18″ pieces to each end of the 36″ piece, right sides together, using a 1/2 inch seam. . Repeat with the other 36″X11″ piece and the other two 18″ X 11″ pieces. Press seams open.  You will now have two pieces that measure about 71″ X 11″.

Find the center of the 71″ X 11″ pieces and mark it in the seam, so that you can match it to the center of the 72″ X 44″ piece. Pin the long edge of one 71″ X 11″ piece to the long edge of the 72″ X 44″ piece, right sides together, matching centers. Stitch together using a 1/2 inch seam. Press seam open. Repeat with the other 71″ X 11″ piece on the other side of the 72″ X 44″ piece.

Now that you have sewn all the pieces together, you will have a large almost square piece. Fold in half, then fold in half again n the bias. Lay this out flat on the floor or other large surface.

Cut the open end of the fabric in a curve.

Cut the open end of the fabric in a curve like this.

Cut the wide end of the folded fabric in a curve, like the one shown above, as close to the edge of the fabric as you can. When the fabric is unfolded, it will be a circle. Press under 1/4 inch around the entire circle. Stitch. Press under 1/4 inch again, stitch. Your round tablecloth will be complete.

My round tablecloth completed.

My round tablecloth completed.

Once my round tablecloth was completed, I felt like it needed some new cloth napkins to go with it. So, I made some using some solid dark burdundy Kona Cotton fabric from Joann Fabrics. These were a lot easier to make than the tablecloth. Just cut out a square the size you want, and stitch a rolled hem all the way around. Cut. Sew. Done. If you want to know how big to cut them I would say use a 22″ square for each one. A yard of fabric will make 4 napkins that size. The ones I made are just a bit too small, and I cut them 16″ square.

The burgundy fabric I used for my napkins.

The burgundy fabric I used for my napkins.

And then….after I made my napkins, I decided that I needed a nice set of napkin rings to use with them. To make my napkin ring, I cut a piece of 3/8 inch burgundy grosgrain ribbon 18″ long. I strung a 16mm bead on the ribbon and centered it in the middle of the 18″ length. Then, I threaded the ends through the bead again, and tied a knot. I added another bead on side of the ribbon, then threaded the other side of the ribbon through the second bead until it was tight against the knot of the first bead. I continued adding beads in this manner until I had six beads strung. I tied a knot, then strung the ends of the thread through the first bead, and pulled it tight. When this was done, I tied a bow, leaving the ends of the ribbon. Here is what my napkin rings look like”

My napkin rings

My napkin rings

Now that my tablecloth, napkins, and napkin rings are done, I can hardly wait for Thanksgiving day to get here! I had fun making them, and I hope that my family and friends like them too.

You can make so many pretty things with supplies, fabric, and crafting materials found in the Joann Craft Catalog.

And, you can save money too, with the 50% off one item coupon below. It is valid until Nov 30, 2013, either in the store or online.

Print and take to the store

Print and take to the store or use the code for online shopping.

What are you going to be making?

 

 

I’m Getting Ahead Of Myself But I Gotta Show You This!

I want to tell you about my visit from Gaelyn from Geogypsy, and how we went to the gem and mineral show in Quartzsite, but I am just too excited about the stuff we Lynda and I have been making that I am jumping ahead to show you:

I love pink things, and this here necklace is pink. It is made with rose quartz and glass and crystal beads. It turned out really good, better than I thought it would.

(click on the pictures to see them better)

This one is made with Chinese turquoise nuggets. I like to take old things apart and use the parts in new pieces, so the chain used in this necklace came from a junkstore find. It looks really good, too.

A few years ago, my mother-in-love, Nana, gave me some lessons in wire wrapping, (Thank you, Nana!) but I have not done much of it until now. I made the bracelet below with the green beads, then Lynda made the one with the purple beads. Mine turned out pretty good, except that the beads I used were too big so it made the overall bracelet too big. We are going to a wire wrapping class next week to learn how to do some other things, and we can hardly wait to go!

I bought these 18mm turquoise beads at the show, because I had an idea for a necklace in my head (yeah, that happens too much). I spent today making all those little curly links for a chain, then Lynda showed me how to make jump links, which is a pretty handy thing to know. I have been making each one separate, which is a major pain in the arse! But look how easy it is here:

And here you can see a little bit of the chain and how the beads look with it. And I put that tape measure in there so you see how big the beads are. It is going to be awesome!